Fiberglass Ladder

Scenario:

I have just an addition to my house. I've heard that is blown into the isolation of better than batts since covers the borders completely and leaves no open spaces. Do you have any suggestions do it yourself?

Solution:

Yes, they're right. Blown in insulation batts is better if it installed correctly, as it has better seal in the attic.

First, you need your attic area that you measured on insulating plan. Most attics require a value of R-30, R-38 or R-49,depending on climate and location. Once you know the size of your attic you can, how much insulation you through a simple search on the map on the bag is the insulation must be determined.

Before you begin, you must determine what materials you need to. Suppose your house has lights, ceiling and bathroom fans and eave vents you the following tools and materials must be deepened:

Loose Fill Insulation

CardboardBaffles

Flashing

Duct Tape

Staple Hammer and Staples

Utility Knife

Ladder

Insulation Blowing Machine (Available at your local rental store)

The attic will need to prepare before you actually blow insulation into it. Make sure you wear a dust mask, goggles and a long-sleeved shirt. Downlights have flashing installed around them leaving a open space flashes of at least four inches from that at the light.With a knife, cut a piece of flashing of the correct length and shape into a cylinder shape, securing the edge with duct tape. Location of the recessed light leaving a four inch open area. This allows the heat to escape. The same procedure is used for all ventilated kitchen or bathroom fans in the attic.

The next step is taken aback. That is a chore nobody enjoys. The fixtures must be installed by using your staple hammer, and then install it, where the beams intersect with roofRafters. Make sure that you only install the baffles over the vents and that they are high enough so that the vents do not get covered with insulation. Now that you have installed, you may want to get off the ground and give you back a much-needed rest.

The next step of preparation is to make a dam around the attic access hole. The easiest way to cut a few extra fittings box in lengths of about 4 cm above the amount of insulation you plan to install. Simply staple them around theLimits the access hole. This will allow for a uniform depth in. They blow in the insulation

So you do not have to keep crawling in and out of the attic, it is best to help another person outside, you have to load the insulation blowing machine. Tip: If you are using fiberglass insulation have your helper add about a cup of water per bag, spreading it over the edge after loading onto the machine. This will help to static electricity cut off when you blow theIsolation and it is set uniform, if you install it. After the sack of insulation is in the funnel, it will take several minutes is required to load the next bag. Have your helper lazy. Let's get him on the ladder and pull it over hose from the attic for you, so you do not get tangled in them.

I've found blowing insulation into the attic is a simple process. Start and the ends of the attic. Back and forth make sure the level and smooth. Make sure get all areas of the attic, and fill any vents or recessed light areas. Take a tape measure with you and check the numbers once in a while. As an example, if your installation of a R-of fiberglass insulation up to 38 want it to be measured 16 centimeters deep. As you work your way back near the attic access make sure that your helper, that more and more hose from the road. If you stop about 6 feet from the access hole the machine so you can get on the ladder. Once on theFinish installing> ladder, making sure that bringing the level equal to the dam you previously built too.

The last step is to create a piece of batt insulation in the access hole and carefully place in the attic hole lid back into place. Now your done! Keep in mind that the attic as much as possible has increased from this point as loose fill insulation, or crushed, it loses on the R-value.